TPMS Car Tire Pressure Monitoring System TYPE-VW1-315 not Require Device to Activate

Description

VW Self-learning tire pressure sensor is a TPMS sensor that does not require device to activate. Please install it on the car and follow the self-learning steps to complete matching and activation.
It can monitor the current tire pressure and temperature. It provides safety guarantee for the driver.
Scenes to be used:the original tire pressure sensor is damaged / doesn’t work/ cannot be matched and activated again / the battery is low and the display value is incorrect

Top 10 Reasons to Get VW self-learning tire Pressure Sensor

1. No need professional tools to match and activate the TPMS.
2. Easy to install
3. Dustproof, waterproof, cold resistance and aging resistance, support tires running at high speed, high air tightness.
4. Support high-speed self-learning
5. Foresee air leakage: When air leakage reaches a dangerous level, the tpms system will issue an alarm.
6. Prevent tire blowouts: Real-time monitoring of tire pressure and temperature, when abnormal tpms occurs, the system will alert you.
7. Prevent tire bulge. Tire pressure overheating and high pressure may cause tire cord breaking and rubber aging.
8. tpms sensor can monitor the current tire pressure and temperature in real time for 24 hours.
9. Standard tire pressure and temperature can extend the life of the tire.
10. Provide safety guarantee for users to trip.

Note:
You only need to replace the broken tire sensors, not all four tires before matching and activation. It is compatible with the original tpms sensor without causing the tpms system to work abnormally.

Workable VW models and Year

How to install VW Self-learning tire pressure sensor?

1. Dismantle the tire.

2. Take off the tpms sensor of the original car

3. Install VW Self-learning tire pressure sensor

4. Inflate the tires and install it on the car, prepare for self-learning.

Reset Successfully.

5 points to note:

1. The driving speed cannot be lower than 30Km/h (20mph)
2. Need to drive the car to the relatively unobstructed road section (about 20km, with fewer traffic lights and few stops, which can improve the success rate of self-learning, usually it will take 6-20 minutes. Too many stops on the road will lead to learning failure, and then drive the car on the unobstructed road section to relearn.)
3. The inflation pressure cannot be too high or too low. Must comply with the tire pressure set by the vehicle tpms.
4. It covers the year when the car was manufactured, not the year when the customer bought the car.
5. It is suitable for users who installed tpms sensor in the car, and need to replace the broken tpms sensor.

Reasons for learning Failure:

1. The speed is lower than 30Km/h (20mph) [solution: please control the speed]
2. During the driving, there are too many pauses [Solution: drive to the road in good conditions to re-learn.]
3. In addition to the tpms sensor of the original car, a third-party tpms sensor is installed [remove the third-party tpms sensor]
4. The tire pressure does not meet the calibration value of the car [Adjust tire pressure]
5. Doesn’t support the year model [Please use it on a supported vehicle]