Reverse Shift Lever Clearance Inspection

Reverse Shift Lever Clearance Inspection

1. Measure the clearance between the reverse shift lever (A) and reverse shift fork (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 2.





2. Measure the width of the reverse shift lever.

^ If the width is not within the standard, replace the reverse shift lever.
^ If the width is within the standard, replace the reverse shift fork.





3. Measure the clearance between the reverse shift lever (A) and reverse shift piece (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 4.





4. Measure the width of the reverse shift lever.

^ If the width is not within the standard, replace the reverse shift lever.
^ If the width is within the standard, replace the reverse shift piece.