Audio Remote Switch Does Not Work Properly (With Navigation)
Symptom Troubleshooting: Audio remote switch does not work properly
Audio remote switch does not work properly (with navigation)
NOTE:
- Check the vehicle battery condition first.
- Check the connectors for poor connections or loose terminals.
1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
2. Turn on the audio-navigation unit, and check the audio remote switch operation (volume up, volume down, CH (UP), CH (DOWN), MODE).
Is the audio system operation OK?
YES - Intermittent failure, the audio remote switch is OK at this time. Check for loose connections.
NO - Go to step 3.
3. Test the audio remote switch. Audio Remote Switch Test
Is the audio remote switch OK?
YES - Go to step 4.
NO - Replace the audio remote, HFL-navigation voice control switch. Steering Wheel Disassembly/Reassembly
4. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
5. Remove the audio-navigation unit. Audio-Navigation Unit Removal/Installation (With Navigation)
6. Disconnect audio-navigation unit connector A (24P).
7. Reconnect the audio remote switch, and measure the resistance between audio-navigation unit connector A (24P) terminals No. 5 and No. 16 as specified in the table.
AUDIO REMOTE SWITCH TABLE
Is the resistance OK?
YES - Go to step 8.
NO - Repair short or high resistance in the circuit between the audio-navigation unit and the audio remote switch. If the wires are OK, replace the cable reel. Service and Repair
8. Disconnect the audio remote, HFL-navigation voice control switch 12P connector.
9. Check for continuity between body ground and terminals No. 5 and No. 16 of audio-navigation unit connector A (24P) individually.
Is there continuity?
YES - Repair short to body ground in the circuit between the audio-navigation unit and the audio remote switch. If the wires are OK, replace the cable reel. Service and Repair
NO - Replace the audio-navigation unit. Audio-Navigation Unit Removal/Installation (With Navigation)