Canada Models with Navigation

Navigation System DTC Troubleshooting: 2607

DTC 2607:

XM Diag

Canada models

NOTE:

- Check the vehicle battery condition first Testing and Inspection.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Check the most recent DTC Reading and Clearing Diagnostic Trouble Codes.

2. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, then back to ON (II), or the ON mode.

3. Check the most recent DTC Reading and Clearing Diagnostic Trouble Codes.

Is Hard Error 2601 indicated at the time you cycled the vehicle?

YES -

Do the 2601 troubleshooting.

NO -

Go to step 4.

4. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode in the Select Diagnosis Items menu Navigation System Diagnostic Mode 1.

5. Check the System Links.

Is the XM icon red?

YES -

Go to step 6.

NO -

Intermittent failure, the system is OK at this time.�

6. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

7. Check for poor connections or loose terminals at these items:

- Navigation display unit 32P connector
- XM receiver connector A (14P) and B (2P)

Are the connections OK?

YES -

Go to step 8.

NO -

Repair poor connections or loose terminals.�

8. Disconnect these items:

- XM receiver connector A (14P)
- Audio-navigation unit connector C (14P)

9. Connect XM receiver connector A (14P) terminals No. 9 and No. 10 with a jumper wire.






10. Check for continuity between navigation display unit 32P connector terminals No. 24 and No. 25.





Is there continuity?

YES -

Do the XM receiver troubleshooting.�

NO -

There is an open in the wire(s) between the XM receiver and the audio-navigation unit. Replace the affected shielded harness.�