Ex-11

SRS DTC Troubleshooting: Ex-11 (x can be 0 thru 9 or A thru F)

DTC Ex-11 ("x" can be 0 thru 9 or A thru F):Control Operation Recorded

NOTE:

- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information. Reading and Clearing Diagnostic Trouble Codes

- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software, SRS Unit Update and retest.

1. Clear the DTC with the HDS. Reading and Clearing Diagnostic Trouble Codes

2. Turn the ignition switch to ON (II), then wait for 10 seconds.

3. Check for DTCs with the HDS. Reading and Clearing Diagnostic Trouble Codes

Are DTC Ex-11 indicated?
YES - Faulty SRS unit, replace the SRS unit. SRS Unit Replacement

NO - Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. Reading and Clearing Diagnostic Trouble Codes If another DTC is indicated, troubleshoot the DTC.