Front Crankshaft Seal: Service and Repair

Pulley End Crankshaft Oil Seal Installation - In Car

Special Tools Required

- Oil Seal Driver, 64 mm 07OAD-RCAA100

1. Remove the timing belt drive pulley:

- J35Z6 engine Service and Repair
- J37A4 engine Service and Repair

2. Remove the pulley end crankshaft oil seal.

3. Clean and dry the crankshaft oil seal housing.

4. Apply a light coat of new engine oil to the lip of the crankshaft oil seal.

5. Using the oil seal driver, 64 mm, drive in the new crankshaft oil seal (A) until the oil seal driver bottoms on the oil pump.





6. Clean the excess oil off the crankshaft, and check that the oil seal lip is not distorted.

7. Install the timing belt drive pulley:

- J35Z6 engine Service and Repair
- J37A4 engine Service and Repair