33 33 101 Replacing Two Rubber Mounts (Front) for Rear Axle Carrier

33 33 101 Replacing two rubber mounts (front) for rear axle carrier

Special tools required:







Necessary preliminary tasks:
- Lower rear axle support







If necessary assemble special tools 33 4 140 , 33 4 142 and 33 4 147 as illustrated.
If necessary screw new synchronizing keys 33 4 149 onto special tool 33 4 140 with countersunk screws







Coat top edge of rubber mount with Circo Light (refer to BMW Parts Service).
Fit special tool 33 4 431 on rubber mount in such a way that edge of rubber mount disappears in special tool.
Oil special tool 33 4 436 lightly before use.
Align special tool 33 4 140 by way of openings in rubber mount.

NOTE: Ensure it is correctly supported on bearing bushing of rear axle carrier.

Using the special tools 33 4 436 , 33 4 437 , 33 4 140 and 33 4 431 , pull rubber mount out of bearing bush.







Installation:
Coat new rubber mount with Circo Light (refer to BMW Parts Service).

Oil special tool 33 4 434 lightly before use.
If necessary, assemble 33 4 432 , 33 4 433 , 33 4 435 and 33 4 434 as illustrated.
Align rubber mount by way of arrow to direction of travel.
Draw in rubber mount as far as it will go.







After installation:
- Bleed braking system