32 41 445 Replacing Return Line (From Cooler to Oil Reservoir)

32 41 445 Replacing Return Line (From Cooler To Oil Reservoir)







WARNING:
Danger of poisoning if oil is ingested/absorbed through the skin.
Risk of injury if oil comes into contact with eyes and skin.

IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.







Recycling:
Catch and dispose of hydraulic fluid in a suitable collecting vessel.







Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove left charge air duct/pressure pipe (N55/N57)
- Removing intake duct (N63)







Release hose clamp (1) and detach cooler return line from fluid reservoir (2).

Installation note:
Make sure hydraulic line is laid without tension and with sufficient distance to adjoining components.







Expose cooler return line up to connection on power steering cooler.







Release quick-release coupling and seal power steering cooler connection with a suitable plug.

Installation note:
Make sure hydraulic line is laid without tension and with sufficient distance to adjoining components.







After installation:
- Carry out initial Dynamic Drive operation
- Check line connections for tightness