72 11 092 Removing and Installing/Replacing Rear Left or Right Seat Belts

72 11 092 Removing and installing/replacing rear left or right seat belt (roller)







Necessary preliminary work:
- Remove backrest

NOTE:
Illustration shows removal of left side.
The right side is removed in the same way as the left side.







Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of hardening)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Release screw (1).
Tightening torque 72 11 23AZ.

Installation note:
Replace microencapsulated screw.1
Remove reversing clip (2).







Installation note:
Align the seat belt guide lop parallel to the screw connection.







Release screw (1).
Tightening torque 72 11 20AZ.
Remove inertia reel unit (2).

Installation note:
Inertia reel unit (2) is coded against incorrect installation.







Release screw (2).
Tightening torque 72 11 21AZ.
Remove seat belt.

Installation note:
End fitting (1) is encoded against incorrect assembly with limit position (3).