24 13 015 Replace Radial Shaft Seal For Output Flange (GA8HP45Z)

24 13 015 Replace Radial Shaft Seal For Output Flange (GA8HP45Z)

Special tools required:







IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation







IMPORTANT:
After completion of repair work, check transmission oil level.
Use only the approved transmission oil.
Failure to comply with this requirement will result in serious damage to the automatic transmission.







Necessary preliminary tasks:
- Remove rear underbody protection.
- Remove complete exhaust system.
- Remove transmission cross member.
- Remove propeller shaft.
- Support transmission with lifter.







Release transmission support block from transmission.
Tightening torque 22 32 1AZ.







Grip output flange (1) with special tool 23 0 020.
Release nut with special tool 24 2 380.
Tightening torque 24 13 1AZ.

Installation note:
Replace nut and secure with a mandrel (8 mm) by caulking.







Detach output flange from output shaft.
Remove spacer.







Attach special tool 24 2 353 to output shaft (1).







Screw in special tool 24 2 351 until it is firmly connected with radial shaft seal.
Pull out radial shaft seal by screwing in special tool 24 2 352.







Oil sealing lip on radial shaft seal (1).
Drive in radial shaft seal (1) with special tool 24 2 370 and adapter ring 24 2 410 as far as it will go.