Master Cylinder Installation

For additional informations see Notes, Warnings, and Hints. Fundamentals and Basics

Removing/Installing Master Cylinder Assembly:

- Install master cylinder and attaching nuts and torque to 30 - 45 Nm (22 - 30 ft. lb.).
- Install pushrod to brake pedal (manual master cylinder).

Failure Warning Switch:

- Install electrical connector at warning switch.
- Install hydraulic lines and tube nuts and torque to 14 - 20 Nm (120-180 in. lb.).
- Fill master cylinder to proper level with clean brake fluid. Proper level is between min. and max. indicator levels in opening on top reservoir.
- Bleed hydraulic system. Service and Repair
- Recheck fluid level.