Transmission Rear Mount Replacement

Transmission Rear Mount Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the left tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
3. Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
4. Using a suitable jack stand, support the rear of the powertrain.




5. Remove the transmission mount to bracket through bolt (1).




6. Remove the transmission mount to transmission bolts (2).




7. Remove the rear mount to frame fasteners (1, 2), then remove the mount from the vehicle.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Using the outline made by the spray paint or marker, install the transmission mount to transmission bolts (2) and tighten to 100 Nm (74 lb ft).




2. Install the transmission mount to bracket through bolt (1) and tighten to 100 Nm (74 lb ft).




3. Install the rear mount to frame fasteners (1, 2) and tighten to 110 Nm (81 lb ft).
4. Perform the Powertrain Mount Balancing - Lower. Refer to the appropriate engine section.
5. Remove the jack stand.
6. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
7. Lower the vehicle.