Ashtray Replacement - Without RPO D55

REMOVAL PROCEDURE
1. Open the ashtray.
2. Remove the 4 fasteners (10) retaining the ashtray (9) to the IP.

Partially remove the ashtray.
3. Disconnect the electrical connector. Remove the ashtray.

INSTALLATION PROCEDURE
1. Partially install the ashtray.

Connect the electrical connector.
2. Align the ashtray (9) to the IP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ashtray fasteners (10).

Tighten
Tighten the fasteners to 1.6 N.m (14 lb in).

3. Close the ashtray.