Battery Negative Cable Replacement (LY7 and LLT (LHD) With Top Post)

Battery Negative Cable Replacement (LY7 and LLT (LHD) With Top Post)

Removal Procedure

Important:
* Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.

* Always route the replacement cable the same as the original cable.




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) (Service and Repair)Battery Negative Cable Disconnection and Connection (LHD Top Post) (Service and Repair) .




2. Disconnect the I/P harness electrical connector (1) from the battery current sensor (2).




3. Disconnect the cable retaining clip (4) from the stud (3) on the shock tower.
4. Remove the bolt (1) securing the negative battery cable (2) to the shock tower.
5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service Intervals) .




6. Remove the bolt (2) securing the negative battery cable (1) to the engine block.
7. Lower the vehicle.
8. Remove the negative battery cable.



Installation Procedure





1. Position the negative battery cable.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the bolt (2) securing the negative battery cable (1) to the engine block.

Tighten the bolt to 50 N.m (37 lb ft).





3. Connect the cable retaining clip (4) from the stud (3) on the shock tower.
4. Install the bolt (1) securing the negative battery cable (2) to the shock tower.

Tighten the bolt to 10 N.m (89 lb in).





5. Connect the I/P harness electrical connector (1) to the battery current sensor (2).
6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) (Service and Repair)Battery Negative Cable Disconnection and Connection (LHD Top Post) (Service and Repair) .