Roof Console Replacement

Roof Console Replacement

Removal Procedure




1. Remove the screw from the overhead console.




2. Use a small, flat-bladed tool in order to release the 2 retainers. These retainers are located on each side of the assembly in front of the switches. Press the retainers outward to release the assembly.




3. Remove the overhead console from the headliner.
4. Disconnect the electrical connectors from the overhead console.




5. Remove the overhead console from the vehicle.
6. Remove the screws from the drivers information center module.
7. Remove the drivers information center module from the overhead console.

Installation Procedure




1. Install the drivers information center module to the overhead console.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the drivers information center module screws.

Tighten the screws to 2 Nm (18 lb in).





Important: When installing the overhead console, apply a foam type tape to the wiring harness to relocate and secure the wiring harness in the proper position to the headliner.


3. Apply foam tape to the wiring harness at the headliner.
4. Connect the electrical connector to the overhead console.




5. Position the overhead console to the mounting bracket in the headliner.
6. Install the overhead console pressing into place in order to fully seat the retainer tabs.




7. Install the screw to the overhead console.

Tighten the screw to 2 Nm (18 lb in).