Air Flow Meter/Sensor: Service and Repair

The MAF sensor on this engine is attached to the throttle body assembly.




Removal Procedure
1. Turn OFF the ignition.
2. Remove the Injector Sight Shield.
3. Disconnect the MAF sensor electrical connector.
4. Remove the screws holding MAF sensor to throttle body.
5. Remove the MAF sensor from the throttle body.

Installation Procedure
1. Carefully position the MAF sensor to the throttle body.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the screws holding the MAF sensor to the throttle body.

3. Tighten
Tighten the screws to 3 N.m (27 lb in).

4. Connect the electrical connector.
5. Install the Injector Sight Shield.