Accelerator Pedal: Service and Repair

REMOVAL PROCEDURE
(Accelerator Controls Pedal shown similar)

1. Remove the left instrument panel sound insulator.
2. Disconnect the accelerator cable (5) from accelerator pedal (1).
3. Remove the bolts (3) and studs (2) holding the accelerator pedal to the bulk head (4).
4. Remove the accelerator pedal.

INSTALLATION PROCEDURE
(Accelerator Controls Pedal shown similar)

IMPORTANT: The throttle should operate freely without binding between a full closed and a wide open throttle.

1. Position the accelerator pedal (1) to the bulkhead (4).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the accelerator pedal bolt (3) and the stud (2).

Tighten
The accelerator pedal assembly bolts and studs to 3.0 N.m (27 lb in)

3. Connect the accelerator cable (5) to the accelerator pedal (1).
4. Reinstall the left instrument panel sound insulator.
5. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.