Enabling the SIR System

1. Connect the driver side air bag yellow 2-way connector (4) located under the driver seat, if the vehicle is equipped with a driver side air bag.
2. Install the CPA to the driver side air bag yellow 2-way connector.




3. Connect the frontal air bags yellow 4-way connector located at the RH side of the instrument panel.
4. Install the CPA to the frontal air bags yellow 4-way connector.
5. Connect the frontal air bags yellow 4-way connector to the metal rail.
6. Instal the RH instrument panel access hole cover.




7. Install the SDM fuse to the LH fuse block.
8. Install the LH instrument panel access hole cover.
9. Staying well away from the airbags, turn ON the ignition.
9.1. The AIR BAG warning lamp will flash seven times.
9.2. The AIR BAG warning lamp will then turn OFF.
10. Perform A Diagnostic System Check SIR if the AIR BAG warning lamp does not operate as described.