Hazard Warning Switch: Service and Repair

REMOVAL PROCEDURE




1. Apply the parking brake.
2. Position the transaxle shift control indicator to 1, if equipped with column shift.
3. Adjust the steering wheel for access.
4. Remove the ignition switch cylinder bezel.




5. Remove the RH and LH instrument panel (IP) fuse block access opening covers. (Impala Only)
6. Remove the LH instrument panel (IP) fuse block access opening cover. (Monte Carlo Only)
7. Remove the steering column filler.
8. Open the instrument panel compartment door. (Monte Carlo Only)
9. Remove the IP cluster trim plate screws.
10. Start at the left side of the IP cluster trim plate. Grasp the trim plate and carefully pull rearward. Disengage the IP cluster trim plate in order to easily access the hazard warning switch.




11. Disconnect the electrical connectors from the hazard warning switch.
12. Remove the hazard warning switch from the IP cluster trim plate.

INSTALLATION PROCEDURE




1. Install the hazard warning switch to the IP cluster trim plate.
2. Connect the electrical connector to the hazard warning switch.




3. Press the IP cluster trim plate into the IP trim pad, until all of the retainers are fully seated.
4. Install the IP cluster trim plate screws.

Tighten
Tighten the IP cluster trim plate screws to 2 N.m (18 lb in).

5. Install the LH instrument panel (IP) fuse block access opening cover. (Monte Carlo Only)
6. Install the steering column filler.
7. Close the instrument panel compartment door. (Monte Carlo Only)




8. Install the ignition switch cylinder bezel.
9. Reposition the steering wheel to the original position.
10. Position the transaxle shift control indicator to Park, if equipped with column shift.
11. Release the parking brake.