On-Vehicle Service

Removal Procedure





1. Remove the case side cover. Refer to Case Side Cover Replacement.
2. Disconnect the wiring harness assembly (224) from the following components:
- Automatic transaxle fluid pressure manual valve position switch (395)
- 1-2 shift solenoid (315A)
- 2-3 shift solenoid (3158)
- Torque converter clutch PWM solenoid (334)
- Pressure control solenoid (322)
- Automatic transaxle input speed sensor (440)
- Wiring harness clips





3. Remove the wiring harness assembly (224).





4. Inspect the wiring harness assembly (224) for:
- Cut or pinched wires
- Cut wire insulation
- Bent or broken electrical connections
- Damaged terminal pins

Installation Procedure





1. Install the wiring harness assembly (224).





2. Connect the wiring harness assembly (224) to the following components:
- Automatic transaxle fluid pressure manual valve position switch (395)
- 1-2 shift solenoid (315A)
- 2-3 shift solenoid (31513)
- Torque converter clutch PWM solenoid (334)
- Pressure control solenoid (322)
- Automatic transaxle input speed sensor (440)
- Wiring harness clips
3. Install the case side cover. Refer to Case Side Cover Replacement.