Valve Cover: Service and Repair

Camshaft Cover Replacement

Removal Procedure





1. Remove the intake manifold cover.
2. Remove the air cleaner outlet duct.
3. Disconnect the intake (3) and exhaust (2) camshaft position actuator solenoid valve electrical connectors.





4. Remove the ignition coils.
5. Remove the engine harness clips (1, and 2) from the cover.





6. Remove the camshaft cover bolts.
7. Remove the camshaft cover.

Installation Procedure





1. Notice: Refer to Fastener Notice in Service Precautions.

Install the camshaft cover and bolts.
^ Tighten the bolts to 10 Nm (89 inch lbs.).





2. Install the ignition coils.
3. Install the engine harness clips (1, and 2) to the cover.





4. Connect the intake (2) and exhaust (2) camshaft position actuator solenoid valve electrical connectors.





5. Install the PCV hose to the cover.
6. Position the PCV hose clamp.
7. Install the intake manifold cover.