Powertrain Mount Balance - Lower Mount

Powertrain Mount Balance - Lower Mount

Important: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Loosen, but DO NOT REMOVE the front transmission mount through bolt.




3. Loosen, but DO NOT REMOVE the rear transmission mount through bolt.
4. Rock the powertrain vigorously from front to rear and allow the powertrain to settle.

Notice: Refer to Fastener Notice.

5. Tighten the rear transmission mount through bolt.

Tighten the bolt to 90 N.m (66 lb ft).




6. Tighten the front transmission mount through bolt.

Tighten the bolt to 90 N.m (66 lb ft).

7. Lower the vehicle.