Digital Radio Receiver Replacement (Sedan)

Digital Radio Receiver Replacement (Sedan)

Removal Procedure


Important: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.


1. Remove the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement (Service and Repair) .




2. Disconnect the electrical connectors from the receiver.




3. Remove the fastener from the receiver and remove the receiver.



Installation Procedure






Notice: Refer to Fastener Notice (Fastener Notice) .

1. Install the receiver and secure with the fastener.

Tighten the fastener to 3 N.m (26 lb in).





2. Connect the electrical connector to the receiver.
3. Install the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement (Service and Repair) .
4. Perform the setup procedure for the digital radio receiver. Refer to Control Module References (Programming and Relearning) for programming and setup information.