Engine Oil Dip Stick - Dip Stick Tube: Service and Repair

Oil Level Indicator and Tube Replacement

Removal Procedure





1. Remove the spark plug wire from the number 6 cylinder spark plug.
2. Remove the heated oxygen sensor (HO2S) electrical connector (3) clip from the indicator tube tab.




3. Remove the oil level indicator.
4. Remove the oil level indicator tube bracket bolt.
5. Remove the oil level indicator tube.
6. Inspect the oil level indicator tube O-ring seal for damage, replace as necessary.



Installation Procedure





1. Lubricate the oil level indicator tube O-ring seal with clean engine oil.
2. Install the oil level indicator tube into the engine block.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the oil level indicator tube bracket bolt.

Tighten the bolt to 25 N.m (18 lb ft).

4. Install the oil level indicator.




5. Install the HO2S electrical connector (3) to from the indicator tube tab.
6. Install the spark plug wire to the number 6 cylinder spark plug.