Blower Motor Resistor: Service and Repair

Blower Motor Resistor Replacement

Removal Procedure

1. Remove the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Service and Repair) .
2. Remove the blower motor resistor wire harness connector.
3. Remove the blower motor resistor screws.




4. Remove the blower motor resistor.



Installation Procedure





1. Install the blower motor resistor.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Tighten the blower motor resistor screws.

Tighten the screws to 1.5 N.m (13 lb in).

3. Install the blower motor resistor wire harness connector.
4. Install the right closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (Service and Repair) .