Transmission Rear Mount Replacement

Transmission Rear Mount Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the left tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
3. Using a suitable jack stand, support the rear of the powertrain.




4. Remove the transmission mount to bracket through bolt (1).




5. Remove the transmission mount to transmission bolts (1).
6. Remove the transmission mount (2).
7. Disconnect the HO2 sensor Harness from the transmission mount bracket.




8. Remove the transmission mount to frame bolts (1).
9. Remove the transmission mount bracket (2).



Installation Procedure





1. Install the transmission mount bracket (2).

Notice: Refer to Fastener Notice .

2. Install the transmission bracket to frame bolts (1).

Tighten the bolts to 50 N.m (37 lb ft).

3. Connect the HO2 sensor harness to the transmission mount bracket.




4. Install the transmission mount (2).
5. Install the transmission mount to transmission bolts (1).

Tighten the bolts to 90 N.m (66 lb ft).





6. Install the transmission mount to bracket through bolt (1).

Tighten the bolt to 90 N.m (66 lb ft).

7. Remove the jack stand.
8. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
9. Lower the vehicle.