P0610

DTC P0610

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.

DTC Descriptor
DTC P0610 00
- Control Module Vehicle Options Incorrect

Circuit/System Description

This diagnostic verifies that the engine control module (ECM) is programmed for the correct vehicle options.

Conditions for Running the DTC

* The ignition is ON.
* The ignition voltage is between 8-16 V.

Conditions for Setting the DTC

The ECM detects that programming for vehicle options is incorrect.

Action Taken When the DTC Sets

* DTC P0610 00 is a Type C DTC.
* The service vehicle soon indicator will illuminate.

Conditions for Clearing the DTC

DTC P0610 00 is a Type C DTC.

Reference Information
Schematic Reference

Engine Controls Schematics ([1][2]Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Powertrain Diagnostic Trouble Code (DTC) Type Definitions)
Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information

Circuit/System Verification

1. Engine running, observe the DTC information with a scan tool. DTC P0610 00 should not set.
2. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.

Circuit/System Testing

1. Program the K20 Engine Control Module. Refer to Control Module References (Programming and Relearning).
2. Clear DTCs with a scan tool.
3. Ignition OFF, allow the K20 Engine Control Module to completely power down.
4. Operate the vehicle within the conditions for running DTC P0610 00.
5. Verify with a scan tool that DTC P0610 00 has not reset.

• If DTC P0610 00 does reset, replace the K20 Engine Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning)for ECM replacement, setup, and programming