B2625

DTC B2625

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor
DTC B2625 02
- Display Dimming Pulse Width Modulation Output Circuit Short to Ground

Diagnostic Fault Information






Circuit/System Description

The body control module (BCM) supplies a reference voltage to the display dimming switch. When the display dimming switch is placed in a desired brightness position, reference voltage is applied through the display dimming switch resistor ladder to the BCM. The BCM interprets this voltage signal, then applies a pulse width modulated (PWM) voltage to the backlight lamp control circuit of the parking assist switch.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The BCM detects a short to ground on the indicator dimming control circuit.

Action Taken When the DTC Sets

The parking assist switch backlight will be inoperative.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.

Reference Information
Schematic Reference

Object Detection Schematics [1][2]Collision Avoidance and Parking Assist Systems
Connector End View Reference

Component Connector End Views Hybrid/EV Battery Pack X1 A4
Description and Operation

Interior Lighting Systems Description and Operation Interior Lighting Systems
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Verification

Ignition ON, command the LED Backlight Dimming ON and OFF with a scan tool. The S48B Multifunction Switch - Overhead Console backlight should turn ON and OFF when changing between the commanded states.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the S48B Multifunction Switch - Overhead Console.
2. Connect a test lamp between the control circuit terminal 1 and ground.
3. Command the LED Backlight Dimming ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

• If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 BCM.

• If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 BCM.

4. If all circuits test normal, test or replace the S48B Multifunction Switch - Overhead Console.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for trailer brake control module replacement, programming and setup