Adding Keys

Adding Keys

Adding Keys (Without SPS)

Note:
* To initiate, this procedure requires that 1 learned key be available.
* A total of 8 keys maybe be learned to a single vehicle.
* This procedure adds keys only. The procedure does not erase previously learned keys.
* The keys to be learned must duplicate the mechanical cut of the current key.

1. Place the recognized key(s) in the vehicle cupholder.
2. Insert the mechanical key of the new transmitter into the key lock cylinder located on the outside of the driver door and turn the key to the unlock position five times within ten seconds. The Driver Information Center (DIC) will display Ready For Remote #2, 3, 4 or 5.

Note: The transmitter slot is located inside the upper instrument panel storage compartment. The rubber mat lining the bottom of the compartment needs to be removed to access the slot.

3. Remove the rubber mat in the instrument panel storage compartment. Extend the key blade on the new transmitter and insert the key into the transmitter slot.
4. Press and hold the vehicle ignition mode switch for two seconds. When the transmitter is programmed, the DIC will show that it is ready to program the next transmitter.
5. Remove the key from the slot and press the unlock button. To program additional transmitters, repeat Steps 3 through 5.
6. When all additional transmitters are programmed, press and hold the ignition mode switch for 10 seconds to exit programming mode.

Adding Keys (With SPS)

Note:
* This procedure may be used with or without existing learned keys being present.
* This procedure will take more than 15 minutes to complete.
* A total of 8 keys maybe be learned to a single vehicle.
* This procedure will only learn the vehicle key information. This procedure will not learn any immobilizer information between the body control module (BCM) and engine control module (ECM).
* If the battery voltage is low, charge the battery before continuing with the procedure.

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).
2. Ensure that all power consuming devices are turned OFF on the vehicle.
3. Select the SPS application and follow the on-screen instructions.
4. Select Reprogram ECU.
5. Select IMMO Immobilizer Learn - Setup.
6. Select the Program Transponder or Remote Key (Add) function.

Note:
* At multiple times during the learn procedure, SPS will instruct you to turn the ignition to the run position. Make sure the vehicle is actually in the run mode before continuing on the SPS terminal. If the igniting is not in the run mode, the learn procedure will fail.
* The transmitter slot is located inside the upper instrument panel storage compartment. The rubber mat lining the bottom of the compartment needs to be removed to access the slot.

7. Follow the on-screen instructions.
8. After programming all keys, Programming Complete, is displayed.
9. Press and hold the ignition mode switch for 15 seconds.
10. Press the lock and unlock button on each transmitter that was programmed. This will awaken each transmitter and allow passive and active keyless entry functions to be established.
11. With a scan tool, clear any DTCs.
12. Verify each key is operating properly. Operate each of the keyless entry functions using the buttons on the transmitter and then start the vehicle. When verifying operation, make sure that no other keys are near the vehicle.