Drive Motor Generator Control Module Cooling Outlet Hose Replacement
Drive Motor Generator Control Module Cooling Outlet Hose Replacement
Special Tools
BO-38185 - Hose Clamp Pliers
For equivalent regional tools, Refer to Special Tools Tools and Equipment
Removal Procedure
1. Drain the cooling system. Refer to Drive Motor Generator Power Inverter Module Cooling System Draining and Filling Drive Motor Generator Power Inverter Module Cooling System Draining and Filling
2. Remove the front wheelhouse front liner on the driver and passenger side. Refer to Front Wheelhouse Front Liner Replacement Front Wheelhouse Front Liner Replacement
3. Remove the drive motor generator control module cooling outlet hose clamp (1) at generator control module coolant pump using BO-38185 - Hose Clamp Pliers.
4. Remove the drive motor generator control module cooling outlet hose (2) from the generator control module coolant pump.
5. Remove the drive motor generator control module cooling outlet hose clamp (1) at drive motor battery charger using BO-38185 - Hose Clamp Pliers.
6. Remove the drive motor generator control module cooling outlet hose (2) from drive motor battery charger.
7. Disconnect the drive motor generator control module cooling outlet hose (1) from the cooling fan and shroud.
8. Remove the drive motor generator control module cooling outlet hose from the vehicle.
Installation Procedure
1. Install the drive motor generator control module cooling outlet hose to the vehicle.
2. Connect the drive motor generator control module cooling outlet hose (1) to the cooling fan and shroud.
3. Install the drive motor generator control module cooling outlet hose (2) to the drive motor battery charger.
4. Install the drive motor generator control module cooling outlet hose clamp (1) at drive motor battery charger using BO-38185 - Hose Clamp Pliers.
5. Install the drive motor generator control module cooling outlet hose (2) to the generator control module coolant pump.
6. Install the drive motor generator control module cooling outlet hose clamp (1) at generator control module coolant pump using BO-38185 - Hose Clamp Pliers.
7. Install the front wheelhouse front liner on the driver and passenger side. Refer to Front Wheelhouse Front Liner Replacement Front Wheelhouse Front Liner Replacement
8. Fill the cooling system. Refer to Drive Motor Generator Power Inverter Module Cooling System Draining and Filling Drive Motor Generator Power Inverter Module Cooling System Draining and Filling