Courtesy Lamps Malfunction

Courtesy Lamps Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

Diagnostic Fault Information






Circuit/System Description

Battery voltage for the courtesy lamps is supplied at all times to the body control module (BCM). When the BCM receives a signal to command the courtesy lamps ON, it then applies voltage through the dome/reading lamps and compartment courtesy lamp control circuit.

Reference Information
Schematic Reference

Interior Lights Schematics Interior Lights Schematics
Connector End View Reference

Component Connector End Views Hybrid/EV Battery Pack X1 A4
Description and Operation

Interior Lighting Systems Description and Operation Interior Lighting Systems
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module Referencesfor scan tool information

Circuit/System Verification

Observe the driver information center while opening and closing each vehicle door and the liftgate. The driver information center should display the door ajar/liftgate ajar message only when the door/liftgate is open.

If the driver information center displays the door ajar/liftgate ajar message when a door or the liftgate is closed, refer to Door Ajar Indicator Malfunction Door Ajar Indicator Malfunction
If the door ajar/liftgate is functioning normal, refer to Courtesy Lamp Circuit Malfunction.

Circuit/System Testing

Courtesy Lamp Circuit Malfunction
1. Ignition OFF, disconnect the harness connector at the E33 Cargo Lamp.
2. Test for less than 10 ohm between the ground circuit terminal 2 and ground.

• If greater than the specified range, test the ground circuit for an open/high resistance.

3. Connect a test lamp between the control circuit terminal 1 and the ground circuit terminal 2.
4. Command the Courtesy Lamps test ON and OFF with the scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

• If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.
• If the test lamp is always OFF, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.

5. If all circuits test normal, test or replace the E33 Cargo Lamp.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Dome and Reading Lamp Replacement Service and Repair
* Dome and Reading Lamp Bulb Replacement Service and Repair
* Control Module References Control Module Referencesfor BCM replacement, setup, and programming