Transmission Fluid Cooler Pipe Connector Replacement - Radiator

Transmission Fluid Cooler Pipe Connector Replacement - Radiator

For equivalent regional tools, Refer to Special Tools Tools and Equipment

Removal Procedure

1. Place a drain pan under vehicle.
2. Remove the transaxle oil cooler hoses from the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection.




3. Remove the oil cooler fitting (1) from the radiator.

Installation Procedure




1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.





Caution: Refer to Fastener Caution Fastener Caution.

Note: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.

2. Install the oil cooler fitting (1) to the radiator and tighten to 38 Nm (28 lb ft).
3. Install the transaxle oil cooler hoses to the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection.
4. Adjust the transmission fluid level.
5. Inspect for fluid leaks.