Front Suspension

Stabilizer Shaft Link Replacement

Special Tools

EN-45059 - Angle Meter

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.




2. Remove the upper stabilizer shaft link nut (1).




3. Remove the lower stabilizer shaft link nut (1).




4. Remove the stabilizer shaft link (1).

Installation Procedure




1. Install the stabilizer shaft link (1).





Caution: Refer to Fastener Caution Fastener Caution.

2. Install the lower stabilizer shaft link nut (1) and using the EN-45059 - Angle Meter, tighten to 60 Nm (44 lb ft) + 30 degrees.




3. Install the upper stabilizer shaft link nut (1) and using the EN-45059 - Angle Meter,tighten to 60 Nm (44 lb ft) + 30 degrees.