Front Crankshaft Seal: Service and Repair

Crankshaft Front Oil Seal Replacement

Special Tools

* EN-960 - Installer

* EN-45000 - Remover Oil seal

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Removal Procedure

1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement Service and Repair.

2. Place a drain pan underneath the front crankshaft seal area.





3. Remove crankshaft front oil seal (2) from engine front cover. Use EN-45000 - remover (1).

Installation Procedure





1. Install NEW crankshaft front oil seal (1) to EN-960 - installer (2).





2. Install crankshaft front oil seal by means of EN-960 - installer (1) to engine front cover (2).





3. Ensure that crankshaft front oil seal (2) is flush with engine front cover (1).

4. Install crankshaft balancer. Refer to Crankshaft Balancer Replacement Service and Repair.

5. Remove the drain pan.

6. Check and correct engine oil level.