Evaporative Emission Control Canister: Service and Repair

Evaporative Emission Canister Replacement (Steel Tank)

Removal Procedure





1. Remove the evaporative emission canister bracket fasteners (1).





2. Disconnect the purge solenoid valve electrical connector (1).

3. Disconnect the evaporative emission canister vent hose (2).

4. Disconnect the evaporative emission canister pipes (3). Refer to Plastic Collar Quick Connect Fitting Service Procedures

5. Remove the evaporative emission canister (4).





6. Release the retaining tab (1) and remove the evaporative emission canister (2).

Installation Procedure





1. Slide the evaporative emission canister (3) into the evaporative emission canister bracket (2) until the retaining tab (1) snaps into position.





2. Install the evaporative emission canister (4) into position.

3. Connect the evaporative emission canister pipes (3). Refer to Plastic Collar Quick Connect Fitting Service Procedures

4. Connect the evaporative emission canister vent hose (2).

5. Connect the purge solenoid valve electrical connector (1).





6. Install the evaporative emission canister bracket fasteners (1) and tighten to 10 Nm (89 lb in).