Parking Brake Cable Replacement

Parking Brake Cable Replacement

Removal Procedure

1. Place the transmission in PARK.
2. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling Parking Brake Cable Adjuster Disabling.
3. Place the power button in the OFF position.

Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.


4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
5. Remove the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
6. Remove the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .




7. Remove the parking brake cable nut (1) from the electronic parking brake control module.




8. Remove the parking brake cable bracket bolt (1).




9. Release the parking brake cable bracket bolt (1) from the vehicle underbody.
10. Remove the fasteners and position aside the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement Service and Repair.




11. Remove the parking brake cable bracket nut (1).




12. Disconnect the parking brake cable equalizer (1) from the left rear parking brake cable.
13. Disconnect the parking brake cable connector (2) from the right rear parking brake cable.
14. Remove the parking brake cable from the vehicle.

Installation Procedure

1. Install the parking brake cable to the vehicle.




2. Connect the parking brake cable equalizer (1) to the left rear parking brake cable.
3. Connect the parking brake cable connector (2) to the right rear parking brake cable.





Caution: Refer to Fastener Caution Fastener Caution.

4. Install the parking brake cable bracket nut (1) and tighten to 10 Nm (89 lb in).
5. Install the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement Service and Repair.




6. Install the parking brake cable bracket nut (1) and tighten to 10 Nm (89 lb in).




7. Install the parking brake cable bracket bolt (1) and tighten to 10 Nm (89 lb in).




8. Install the parking brake cable nut (1) to the electronic parking brake control module and tighten to 6 Nm (53 lb in).
9. Install the left rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement .
10. Install the left rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
11. Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling Parking Brake Cable Adjuster Enabling.