Parking Brake Rear Cable Replacement - Right Side

Parking Brake Rear Cable Replacement - Right Side

Removal Procedure

1. Place the transmission in PARK.
2. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling Parking Brake Cable Adjuster Disabling.
3. Place the power button in the OFF position.

Danger: Do not use a service jack in locations other than those specified to lift this vehicle. Lifting the vehicle with a jack in those other locations could cause the vehicle to slip off the jack and roll; this could cause injury or death.


4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.




5. Disconnect the right rear parking brake cable from the actuator lever (1) on the brake caliper.
6. Compress the locking tabs on the right rear parking brake cable conduit (2) and remove the parking brake cable from the bracket.




7. Release the right rear parking brake cable retainer (1) from the hydraulic brake pipe bracket.




8. Release the right rear parking brake cable retainer (1) from the vehicle underbody.
9. Remove and position aside the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement Service and Repair.




10. Disconnect the parking brake cable connector (1) from the rear parking brake cable.
11. Remove the right rear parking brake cable (2) from the bracket on the vehicle underbody by compressing the locking tabs on the cable conduit.
12. Remove the right rear parking brake cable from the vehicle.

Installation Procedure




1. Install the right rear parking brake cable to the bracket on the vehicle underbody.
2. Connect the parking brake cable connector (1) to the rear parking brake cable.
3. Secure the locking tabs on the cable conduit (2) to the parking brake cable bracket.
4. Install the evaporative emission canister and bracket assembly. Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement Service and Repair.




5. Install the right rear parking brake cable retainer (1) to the vehicle underbody.




6. Install the right rear parking brake cable retainer (1) to the hydraulic brake pipe bracket.




7. Install the right rear parking brake cable to the parking brake cable bracket on rear brake caliper.
8. Connect the right rear parking brake cable to the actuator lever (1) on the brake caliper.
9. Secure the locking tabs on the right rear parking brake cable conduit (2) to the bracket.
10. Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling Parking Brake Cable Adjuster Enabling.