Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection

Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection

Special Tools

GE-41623 - Cooler Quick Connect Tool

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Removal Procedure




1. Install the GE-41623 - cooler quick connect tool onto the transmission oil cooler (TOC) pipe.




2. Slide the GE-41623 - cooler quick connect tool toward the TOC pipe fitting.





Note: Rotate the GE-41623 - cooler quick connect tool to engage the TOC pipe fitting's retainer slots.

The GE-41623 - cooler quick connect tool should be nearly flush with the fitting.

3. Connect the GE-41623 - cooler quick connect tool onto the TOC pipe fitting.




4. Rotate the GE-41623 - cooler quick connect tool until the retainer clip (1) rises above the fitting retainer seat.




5. Pull back on the TOC pipe to disengage the pipe from the TOC pipe fitting.
6. Remove the GE-41623 - cooler quick connect tool from the TOC pipe.

Installation Procedure





Note: Inspect the TOC pipe fitting and retaining clip for signs of wear or damage. Replace the components if necessary.

1. Install the TOC pipe into the TOC pipe fitting.
A distinct snap should be heard or felt when assembling the TOC pipe to the fitting.
2. To ensure the cooler line is properly installed, give the cooler pipe a gentle pull.