Door - Reduce Dirt and Mud Buildup In the Door Sill Area
90chevy02Number: 89-289-10
Section: 10
Date: January 1990 Corporate Bulletin No.: 961006
Subject: DOOR SILL DUST BUILD-UP/DUST INTRUSTION
Model and Year: 1988-89 C, K TRUCK
Figure 1:
TO: ALL CHEVROLET DEALERS
A secondary sealing strip is now available to reduce dirt and mud buildup in the door sill area, and assist in eliminating the entrance of mud, sand, and dirt into the cab area. Additionally, this seal may be used against dust intrusion when used with door filters described in Dealer Service Bulletin No. 88-294-10. The secondary door sealing strips are available in kit P/N 12340815.
Following are the instructions for installing the secondary sealing strips:
1. Raise vehicle.
2. Wash and thoroughly dry door bottoms.
3. Wipe door bottom in the area of the drain slots front to rear with a suitable wax and grease film remover.
4. Test fit and align cut-outs on seal with drain slot depressions in door bottoms, and roll the leading edge of the seal around the curve at the door front stopping against the return flange (View A).
5. With a heat gun, heat attaching area sheet metal.
6. On the seal, remove backing strip, apply heat, and firmly press tape flat against the door bottom between drain slots.
Part is currently available from GMSPO.
For vehicles repaired under warranty, use:
Labor Operation Number: T8055
Labor Time: 0.4 Hrs.