Power Steering Pump Replacement

POWER STEERING PUMP REPLACEMENT






TOOL REQUIRED:
- J 29785-A Puller
- J 25033-B Pulley Installer

REMOVE OR DISCONNECT

- Place a drain pan below the pump.

1. Hoses. Cap the hoses.
2. Loosen the tensioner assembly.
3. Belt.
4. Pulley (35).
- Install J 29785-A. Be sure the pilot bolt bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
- Hold the pilot bolt.
- Turn the nut counterclockwise.

5. Front brace (38) and rear mounting nuts (43).
6. Pump (33).

INSTALL OR CONNECT
1. Pump (33).

2. Rear mounting nuts (43).

TIGHTEN
- Nuts to 23 Nm (17 lbs. ft.).

3. Front brace (38).

TIGHTEN
- Bolts to 40 Nm (30 lbs. ft.).
- Nut to 40 Nm (30 lbs. ft.).

4. Pulley
- Place pulley on the end of the pump shaft.
- Install J 25033-B. Be sure the pilot bolt bottoms in the shaft by turning the nut to the top of the pilot bolt.
- Hold the pilot bolt.
- Turn the nut clockwise.

5. Belt.
6. Hoses.
- Fill and bleed the system.

INSPECT
- Hoses for clearance.