Front Engine Mounts

Front Engine Mount:

Front Engine Mounts:

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Top half of the fan shroud.
3. Raise the vehicle.

CAUTION When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal or crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause it to be bent against the pump screen, resulting in a damaged oil pickup unit.

4. Support the engine with a suitable jack. Do not load the engine mounting.
5. Engine mounting through-bolt and nut.

CAUTION Raise the engine only enough for sufficient clearance. Check for interference between the rear of the engine and the dash panel which could cause distributor damage.

6. Raise the engine only enough to permit removal of the engine mounting.
7. Mounting assembly bolts, nuts, and washers.
8. Mounting assembly.

INSTALL OR CONNECT
1. Mounting assembly.
2. Mounting assembly bolts, nuts, and washers.
Tighten
^ Bolt to 56 Nm (41 ft. lbs.).
^ Nut to 47 Nm (35 ft. lbs.).
3. Engine mount through-bolt and nut. Lower the engine until the bolt can be inserted. Install the nut.
Tighten
^ Through-bolt nuts to 115 Nm (85 ft. lbs.) or nuts to 72 Nm (53 ft. lbs.).