Rear

REMOVE OR DISCONNECT
1. Battery ground cable.
2. Rear duct (303)
3. Blower motor ground strap screw (328) and ground wire (331).
4. Blower motor harness connector (332).

CAUTION: Before removing the case screws, support the lower case to prevent damage to the case or motor assembly.

5. Lower to upper blower-evaporator case screws (334).
6. Lower case (336) and motor assembly (330).
7. Motor retaining strap.
8. Motor and wheels (330) from the lower case.
9. Wheels from the motor shaft

INSTALL OR CONNECT
1. Wheels to the motor shaft (330).
^ Place the tension springs on the wheel hubs.
2. Motor and wheels to the case.
^ Align the wheels to prevent contact with the case.
3. Motor retaining strap and foam.
4. Lower case (336) and motor assembly (330) in the vehicle.
5. Lower to upper case screws (334).
^ Turn the blower wheels to prevent rubbing against the case.
6. Center ground wire (331) and screw (328).
7. Blower harness connector (332).
8. Rear duct (303) as outlined previously.
9. Battery ground cable.