AQ4 Seating - Rearmost Four-Passenger Bench Seat

G-VANS WITH AQ4 SEATING - REARMOST FOUR-PASSENGER BENCH SEAT
Requires Parts Kit #15677204

1. Remove bench seat from vehicle and place upside down on a clean tarp.

2. Remove seat belt retractor.

3. Loosen seat back and bench cover corners by clipping off hog rings.

4. Two holes must now be drilled on each side of the seat assembly. These holes will be located on the centerline of the seat back and bench frames. The first hole location will be on the seat back frame centerline approximately 1/4" below the break line.


5. The hole in the seat bench frame will be located by using the reinforcing rod as a template and holding one end fixed at the point on the seat back frame described in step 4 above. The hole location on the seat bench frame will be where the reinforcing rod intersects the seat bench frame centerline.


6. Holding the reinforcing rod in position, and using a hammer, strike the reinforcing rod to transfer punch marks into seat frame assembly.

7. Drill four (two each side) pilot holes at punched locations using a 1/8" drill.

8. Drill four (two each side) holes at piloted locations using 21/64" drill.

9. Insert reinforcing rod into drilled holes and attach using "push-on" fasteners.

10. Install push-on fasteners so that the reinforcing rod is secured tightly against the seat back and bench frames.

11. Pull down the seat bench cover and hog ring.

12. Pull down the seat back cover and hog ring.

13. Reinstall seat belt retractor according to service manual procedures.

14. Reinstall seat in vehicle.

15. Install Campaign Identification Label.