Rear Wiper Motor

Figure 28:

Figure 29:

REMOVE OR DISCONNECT
1. Battery ground cable.
2. Retainer screws (10) and cover (9) from the wiper motor (1).
3. Wiper arm assembly (8) from the wiper motor (1).

NOTE: For ease of removal and installation of the wiper arm assembly install an 1/8 drift pin through the wiper arm hinge to control the spring detent. Refer to Figure 28.

4. Washer hose from the wiper arm assembly.
5. Glass support arm from the end gate glass and support the end gate glass.
6. Wiper Motor/Hinge bolt (11) from the hinge assembly (7).
7. Nut (6), spacer (5) and flat seal (4) from the wiper motor (1).
8. Wiper motor (1), inner seal grommet (3) and beveled washer (2) from the end gate glass (12).

INSTALL OR CONNECT
1. Beveled washer (2) and the inner seal grommet (3) to the wiper motor (1).
2. Wiper motor (1) to the end gate glass (12).
3. Flat seal (4) spacer (5) and nut (6) to the wiper motor (1).
4. Wiper motor/hinge bolt (11) to the hinge assembly (7).
5. Glass support arm to the end gate glass.
6. Align the end gate glass.

Tighten
^ Nut (6) and to 6 Nm (54 in lbs).
^ Wiper motor/hinge bolt (11) to 6 Nm (54 in lbs).

7. Washer hose to the wiper arm assembly (8).
8. Wiper arm assembly (8) to the wiper motor (1). If drift pin was used, remove after assembly.
9. Retainer screws (10) and cover (9) to the wiper motor (1).
10. Battery ground cable.