Battery Positive Cable Replacement

REMOVAL PROCEDURE




1. Remove the coolant recovery reservoir or surge tank partially from the vehicle.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Disconnect the battery negative cable from the battery.
3. Disconnect the battery positive cable from the battery.




4. Disconnect the positive lead to the starter solenoid.
5. Disconnect the positive lead to the junction block.




6. Disconnect the positive lead to the generator.
7. Remove the cable from the vehicle.

INSTALLATION PROCEDURE




1. Install the cable to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Connect the positive lead to the generator.

Tighten
Tighten the generator output (BAT) nut to 18 N.m (13 lb ft).




3. Install the positive lead to the starter solenoid.

Tighten
Tighten the positive lead to starter solenoid to 10 N.m (89 lb in).

4. Install the positive lead to the junction block.

Tighten
Tighten the junction block nut to 10 N.m (89 lb in).




5. Connect the battery positive cable to the battery.

Tighten
Tighten the battery terminals to 17 N.m (13 lb ft).

6. Connect the battery negative cable to the battery.
7. Install the coolant recovery reservoir or surge tank to the vehicle.