Diesel Data: Automotive Repair
Home >> Chevy Truck >> 2000 >> Tracker 2WD L4-2.0L VIN C >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Air Bag >> Service and Repair >> Inflatable Restraint Instrument Panel Module Replacement

Inflatable Restraint Instrument Panel Module Replacement

LIVE (UNDEPLOYED) INFLATOR MODULE
Refer to Inflator Module Handling, Shipping, and scrapping.

DEPLOYED INFLATOR MODULE
After the inflatable restraint steering wheel module has deployed, the surface of the air bag may contain a powdery residue. This powder consists primarily of cornstarch (which is used to lubricate the bag as it inflates), and by-products of the chemical reaction. The deployment reaction produces sodium hydroxide dust (similar to lye soap). The sodium hydroxide quickly reacts with the atmospheric moisture, creating sodium carbonate and sodium bicarbonate (baking soda). Therefore, you will probably find no sodium hydroxide present after the deployment. As a precaution you should wear gloves and safety glasses, which help to prevent possible irritation of the skin or the eyes.

REMOVAL PROCEDURE




1. Disable the SIR system.
2. Remove the IP compartment.
3. Remove the fasteners from the inflatable restraint IP module (1).
4. Remove the inflatable restraint IP module from the vehicle's instrument panel (2).

INSTALLATION PROCEDURE

CAUTION: When you are carrying an undeployed inflator module:
^ Do not carry the inflator module by the wires or connector on the inflator module
^ Make sure the bag opening points away from you

When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.




1. Install the inflatable restraint IP module (1) into the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the inflatable restraint IP module fasteners.

TIGHTEN
^ Tighten the four bottom center fasteners (bolts) to 23 N.m (16.5 lb ft).
^ Tighten the two upper side fasteners (screws) to 5.5 N.m (4 lb ft).

3. Install the IP compartment.
4. Enable the SIR System.
Diesel-Data.com