Battery Cable Replacement (Positive)

REMOVAL PROCEDURE




1. Remove the bolt retaining the coolant recovery reservoir or surge tank.
2. Move the coolant recovery reservoir or the surge tank aside.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

3. Disconnect the battery negative cable from the battery.




4. Disconnect the battery positive cable from the battery.




5. Disconnect the positive lead to the starter solenoid.




6. Disconnect the positive lead to the generator.
7. Remove the cable from the vehicle. Note the location of the retaining clips.

INSTALLATION PROCEDURE




1. Install the cable to the vehicle.
Ensure the cable is routed correctly and installed in the retainer clips.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Connect the positive lead to the generator.

Tighten
Tighten the generator output (BAT) nut to 18 N.m (13 lb ft).




3. Install the positive lead to the starter solenoid.

Tighten
Tighten the positive lead to starter solenoid to 10 N.m (89 lb in).




4. Connect the battery positive cable to the battery.

Tighten
Tighten the battery terminals to 17 N.m (13 lb ft).

5. Connect the battery negative cable to the battery.




6. Install the coolant recovery reservoir or surge tank and the bolt.

Tighten
Tighten the coolant recovery reservoir or surge tank bolt to 11 N.m (97 lb in).