Power Steering Reservoir Inlet Pipe/Hose Replacement
Power Steering Reservoir Inlet Pipe/Hose ReplacementRemoval Procedure
Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
1. Install a drain pan under the vehicle.
2. Siphon the fluid from the reservoir to prevent excessive spillage.
3. Remove the reservoir inlet hose (3) from the brake booster (2).
4. Remove the reservoir inlet hose (3) from the reservoir.
5. Remove the hose from the vehicle.
Installation Procedure
Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.
1. Route the hose in the same position the hose occupied prior to removal.
2. Smoothly route the hose in order to avoid sharp bends and kinking.
3. Install the reservoir inlet hose (3) to the reservoir. Position the clamp at the end of the hose.
4. Fully crimp the clamp to the hose.
5. Install the reservoir inlet hose (3) to the brake booster (2). Position the clamp at the end of the hose.
6. Fully crimp the clamp to the hose.
7. Check the power steering fluid level.
8. Remove the drain pan from under the vehicle.
9. Bleed the power steering system.