Throttle Body: Service and Repair

Throttle Body Assembly Replacement

Removal Procedure




1. Remove the air cleaner resonator and outlet duct.
2. Disconnect the evaporative emission (EVAP) canister purge pipe (1) from the throttle control module (2).




3. Disconnect the engine wiring harness electrical connector (1) from the throttle body control module.




4. Remove the throttle control module bolts.
5. Remove the throttle control module and the seal from the intake manifold.
6. Clean the gasket surface.

Installation Procedure




1. Insert a NEW seal into the intake manifold groove.
2. Position the throttle body control module to the intake manifold.

Notice: Refer to Fastener Notice.

3. Install the throttle body control module bolts.

Tighten the bolts to 10 N.m (89 lb in).




4. Connect the engine wiring harness electrical connector (1) to the throttle body control module.




5. Connect the EVAP canister purge pipe (1) to the throttle control module.
6. Install the air cleaner resonator and outlet duct.