Power Steering Reservoir Inlet Pipe/Hose Replacement

Power Steering Reservoir Inlet Pipe/Hose Replacement

Removal Procedure





Notice: Refer to Power Steering Hose Disconnected Notice .

1. Install a drain pan under the vehicle.
2. Siphon the fluid from the reservoir to prevent excessive spillage.
3. Remove the reservoir inlet hose (3) from the power brake booster (2). DO NOT reuse clamps.
4. Remove the reservoir inlet hose (3) from the reservoir. DO NOT reuse clamps.
5. Remove the reservoir inlet hose from the vehicle.

Installation Procedure





Notice: Refer to Fastener Notice .

1. Route the hose in the same position the hose occupied prior to removal.
2. Install the reservoir inlet hose (3) to the reservoir. Reposition and secure clamps.
3. Install the reservoir inlet hose (3) to the power brake booster (2). Reposition and secure clamps.
4. Bleed the power steering system. Refer to Power Steering System Bleeding .
5. Remove the drain pan from under the vehicle.